Table of Contents
Advertisement
Service Parts
2
1
Figure 12. Service Parts Diagram.
ITEM
DESCRIPTION
Refractory Kit
1
Side Panel (Qty 2 req)
2
Panel Side (Qty 2 req)
3
Back Panel
G. Granite Instructions
A Granite Kit is available for use with the RED60 models
Install Granite according to these instructions
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
NOTICE: Handle granite pieces with care. Granite may
chip or crack if dropped or impacted.
NOTICE: The installation of the granite kit may require the
air shutter setting to be changed. See Section 9.E of this
manual to ensure the shutter gap is set correctly before
fi ring the appliance.
Note: Optional Porcelain or Granite Kits used with lighted
and non-lighted media models must be placed in appliance
before placing glass media in the appliance.
RED60 Model Without Media
This kit contains the components necessary to install the
granite on RED60 models that do not have media installed.
Kit Contents:
(3) Back panel pieces 19-13/16 inches wide x 16-7/8
inches tall. See Figure 1.
(2) Inner side wall pieces 10 inches wide x 16-7/8 inches
tall. See Figure 2.
3
2
1
PART NUMBER
POR60-L
2159-219
2159-223
2159-222
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
(2) Outside corner trim pieces. See Figure 3.
(7) Securing tabs with (7) sheet metal screws. See Figure 4.
(3) Inner front base pieces 19-3/8 inches long x 4-5/8
inches deep. See Figure 5.
(3) Inner rear Base Pieces 19-3/8 inches long x 3-3/4
inches deep. See Figure 6.
(2) Outside front trim base. See Figure 7.
(2) Front Base Mesh Granite Support. See Figure 8.
(2) Rear Base Mesh Granite Support. See Figure 8.
Tools Required
Cordless Drill
1/4 inch hex head driver tip
Pry Bar and Hammer for opening shipping crate
16-7/8 IN.
19-13/16 IN.
Figure 1. Back Panel Pieces.
16-7/8 IN.
Figure 2. Inner Side Wall Pieces.
Figure 3. Outside Corner Trim Pieces.
10 IN.
75
Advertisement
Table of Contents
