Heat & Glo RED60 Installation Manual page 78

EQUAL GAP DEPTH ON
BOTH SIDES OF GRANITE.
Figure 16. Installing Inner Front Granite Pieces.
10. Install the glass frame assembly.
11. Position access panel so tabs are facing the glass as-
sembly. Insert into glass frame. See Figure 17 and
Figure 18.
12. Install outer front trim base onto shelf as shown in
Figure 19.
GLASS ASSEMBLY
TABS FACE GLASS ASSEMBLY
Figure 17. Positioning Access Panel.
GLASS ASSEMBLY
ACCESS PANEL
Figure 18. Access Panel Installed.
Figure 19. Outer Front Trim Base Installed on Shelf.
13. Install outside corner trim pieces. Slowly slide into
position as shown in Figure 21.
14. Attach retaining tabs at the top by installing the sheet
metal screws into the pilot holes located above the
granite. See Figure 20.
78 Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
GLASS FRAME TAB
RETAINING TAB
Figure 20. Attaching Retaining Tab to Glass Frame Tab.
RETAINING TAB CONTACTS GRANITE
Figure 21. Placing Outer Corner Granite Trim Piece.
Service Parts
5
4
Figure 22. Service Parts Diagram.
ITEM DESCRIPTION
Refractory Kit
1
Outer Bottom Panel (Qty 2 req)
2
Bottom Front Panel (Qty 3 req)
3
Bottom Back Panel (Qty 3 req)
4
Front Corner Panel (Qty 2 req)
5 Panel Side (Qty 2 req)
6 Back Panel (Qty 3 req)
6
6
6
PART NUMBER
GR60-F
2159-217
2159-215
2159-216
2159-214
2159-210
2159-209
5
4