Table of Contents
Advertisement
B. Decorative Fronts
WARNING! Risk of Burns! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
Only decorative fronts certified for use with this appliance
model may be used. Contact your dealer for a list of deco-
rative fronts that may be used.
Note: See appliance Owner's Manual for TV mounting
guidelines.
The doors approved for use with this appliance have been
designed to be installed by two methods: Overlap Fit or
Inside Fit. Before beginning the installation, it is important
to determine with method will be used.
Clean Face Trim Front (CFT)
Overlap Fit (0-1 Inch Thick Finishing Method)
Non-Combustible Finish Materials
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specified in
this manual. Overlapping materials could ignite.
Decorative Front
Clean Face Trim (CFT)
15-3/4 IN.
Figure 10.4 Minimum Finished Opening Dimensions - Clean Face Trim Front Method
Heat & Glo • MEZZO36-B/ST-B, MEZZO48-B/ST-B, MEZZO60-B/ST-B, MEZZO72-B/ST-B Installation Manual • 2300-973 Rev. R • 12/18
Finishing Method
Material Thickness
Overlap Fit
39-1/8 IN.MEZZO36-B/MEZZO36ST-B
51-1/8 IN.MEZZO48-B/MEZZO48ST-B
63-1/8 IN.MEZZO60-B/MEZZO60ST-B
75-1/8 IN.MEZZO72-B/MEZZO72ST-B
FIREPLACE VIEWING AREA
Note:
When a Clean Face Trim decorative front is
installed, the rectangular holes in bottom access panel
will be covered.
NOTICE: This one inch maximum not only includes the
decorative finish materials (marble, tile, slate, etc) but also
the thin set, lath and adhesive used to attach the decorative
finish material.
1. Remove bottom finishing template from bottom access
panel. Verify that factory-installed finishing guards are
installed to ensure finishing material does not extend
into the fireplace opening. See Figure 10.2 and 10.3.
2. The non-combustible finish material, 0-1 inch thick,
should be installed up to the fireplace opening on all
four sides, including the bottom access panel, cover-
ing the eight rectangular holes. Refer to Figure 10.4
for minimum finished opening dimensions.
WARNING! Risk of Fire! DO NOT apply finishing mate-
rial beyond the finishing guard. Appliance will overheat if
finishing material extends into appliance opening.
NOTICE: Decorative front will not fit properly if finishing
material is applied beyond the finishing guard.
4. Follow Overlap Fit section of the instructions provided
with decorative front.
0-1 inch
Included & Used
Trim Ring
53
Advertisement
Table of Contents
