Table of Contents
Advertisement
Start a n d warm-up the engine.
Turn ignition switch to OFF.
•
•
Set shift lever to neutral position. (MT vehicles)
Set selector lever to "P" position. (AT vehicles)
Connect test mode connector and read memory
connector.
Turn ignition switch to ON (engine OFF).
Malfunction indicator lamp is turned ON.
N
Move selector lever to
"
Move selector lever to "P" position. (AT vehicles)
Start the engine.
Drive at speed greater than
one minute.
Warm-up engine above 2,000 rpm.
OK code is ind icated on malfunction indicator lamp.
OFF.
Turn ignition switch to
Disconnect test mode connector and read memory
connector.
FUEL INJ ECTION SYSTEM [TU RBO MODEL]
YES
position.
(AT vehicles)
"
km/h (7 MPH) lor at least
1 1
End
6. Diagnostics Chart for On-board Diagnosis System
E: CLEAR MEM ORY MODE
Inspect ECM power supply and ground line . and
malfunction indicator lamp line.
NO
Trouble code is indicated on malfunction indicator lamp.
Confirm trouble code.
Make sequential checks of trouble codes.
After sequential checks, go to D-check mode again.
1 9
[T6EO)
,
YES
2-7c
Advertisement
Table of Contents
