Subaru 1997-1998 Impreza Service Manual page 482

1 2 ) Turn ignition. switch "OFF"
cable, and wait 20 seconds. Connect connector (AB3) to
(ABS). Disconnect passenger side airbag module connec­
tor (AB9) to (AB10). < Ref. to 5-5 (W3A2]. >
Connect test harness C connector ( 1 C ) to (AB9). Connect
airbag resistor to test harness C connector (3C).
13) Reconnect battery ground cable and turn ignition switch "ON". Does airbag warning light go "OFF" after about
onds and remain off for more than 30 seconds? See notes 1 ) and 2). (Refer to end of chart.)
14)
If "YES", proceed to step 9).
15) 11 "NO", turn ignition switch
ground cable, and wait 20 seconds. Disconnect connector
(AB3) to (AB8). Connect test harness C connector (1C) to
(ABS). Connect airbag resistor to test harness C connec­
tor (3C).
16) Reconnect battery ground cable and turn ignition switch "ON". Does airbag warning light go
onds and remain off lor more than 30 seconds? See notes 1 ) and 2). (Refer to end of chart.)
17) If "YES", turn ignition switch
<
Ref. to 5-5 (W382). > then proceed to step 5).
airbag module
18) II "NO", proceed with diagnostics according to trouble code indicated during on-board diagnostic. Proceed to step 29).
19) Reconnect battery ground cable and turn ignition switch "ON", does airbag warning light go out after about
and remain "OFF" tor more than 30 seconds? See notes 1 ) and 2). (Reter to end
20) If "YES", turn ignition switch "OFF", disconnect battery ground cable and wait 20 seconds. Install driver side airbag
<
Ref. to 5·5 (W3B 1 ) . > and proceed to step 29).
module
2 1 ) If "NO" , remove lower cover panel and connecf tesl har­
ness C connector (1C) to (AB8)
with airbag resistor attached
(3C).
Turn ignition switch "ON". Does airbag warning light go
"OFF" after about 7 seconds and remain off for more
than 30 seconds?
See notes 1 ) and 2). (Refer to end of chart.)
If "YES" proceed to step 22).
If "NO" proceed to step 23).
22) If "YES", replace combination switch, < Ref. to 5-5 IW6AOJ.
23) If "NO". proceed with diagnostics and repair according to trouble code indicated, then perform step 24).
SUPPLEMENTAL RESTRAINT SYSTEM
disconnect battery ground
I
"OFF",
d isconnect battery
"OFF",
disconnect battery ground cable and wait 20 seconds. Install a new passenger side
<
Ref. to 5-4 (W1AO]. >
10
test harness C connector
4. Diagnostics Chart lor On-board Diagnostic System
at
>
and proceed to step 26).
1 5
"OFF"
after about
7
chart.)
[T4D2]
5-5
GSM0589
7
sec­
G5MD429
7
sec­
seconds
G5M0429