Table of Contents
Advertisement
10) If "NO", connect test harness C connector ( l C) to (ABS)
< Ref. to 5-4 (W1AO).> with airbag resistor attached to
test harness C connector (3C).
1 1 ) Turn ignition switch "ON", Does airbag warning light go "OFF" after about 7 seconds and remain off for more than 30
seconds? See notes
1 )
12) If "YES"
replace combination switch. < Ref. to
I
13) If "NO" . proceed with diagnostics according to trouble code indicated during on-board diagnostic.
14) After repair, reconnect test harness C connector ( l e) to
(AB7) < Ref. to
[W3A 1 ). > with airbag resistor
5-5
attached to (3C).
15) Turn ignition switch "ON". Does airbag warning light go "OFF" after about 7 seconds and remain off for more than 30
seconds? See notes
1 )
16) If "YES", disconnect battery. TUrn ignition switch
[W381 ] . > and proceed to step 18).
17) If "NO", replace combination switch, < Ref. to
18) Reconnect battery and turn ignition switch "ON". Does airbag warning light go off after about 7 seconds and remain off
for more than 30 seconds? See notes 1) and 2).
19) If "NO", disconnect battery, turn ignition switch "OFF", replace a new airbag module < Ref. to
step 18).
20) If "YES", perform ctear memory procedure. < Ref. to
21) If memory cannot be cleared, another trouble code exists. Proceed to returning to step 1).
•
•
NOTES:
Always remember to secure the green double locks before turning the Ignition switch "ON" .
In some cases the alrbag warning light will go "OFF" after about
this case continue diagnostics with the basic diagnostics procedures or trouble code procedures.
SUPPLEMENTAL RESTRAINT SYSTEM
and 2}.
5-5
and 2).
5-5
Diagnostics Chart for On-board Diagnostic System
4.
[W6AO]. > and proceed to step 16).
and wait 20 seconds. Install airbag module < Ref. to
"OFF",
IW6AOj. > and proceed to step 16).
[T4CO[. >
5-5
7
seconds but will turn "ON" again within
1 3
[T4D1J
5-5
GSM0429
G5M0430
5-5
[W3A1]. > and repeat
5·5
seconds. In
30
Advertisement
Table of Contents
