Dish Network Satellite Receiver User Manual page 77

Chapter 11 381.fm Page 70 Thursday, May 21, 2009 6:19 PM
Chapter 11
Connecting to a TV
YP P Connections
B R
The YPbPr connections provide high-quality audio and video to your TV set or monitor.
1
Connect between the YPbPr component connections on the receiver and the HDTV using
component video cables.
2
Connect audio (red and white) RCA-type cables between the receiver's audio outputs and the
audio input connections that go with the YPbPr connectors on your TV set or monitor.
3
If you do not see a picture, change the resolution setting on the receiver.
4
Turn up the volume on your TV and confirm you have sound. Check the RCA-type audio
connections if you don't hear any sound.
No Picture on the TV
This section will help you see a picture on the TV in the event that you could not do so in the
previous sections.
1
Connect RCA-type cables between the receiver and the TV set or monitor.
2
Make sure the receiver and TV set or monitor are on.
3
Make sure the TV is set to display the satellite TV connection. Look on the back of your TV and
consult your TV user's guide.
4
Change the TV set or monitor display settings as described in the next section.
5
Switch the TV to display satellite TV from the YPbPr (component) or DISH DVI (digital) inputs. If
you have a picture, you are finished.
6
Repeat steps 4 and 5 until the TV displays the video from the receiver.
70