Dish Network Satellite Receiver User Manual page 57

Chapter 9 381.fm Page 50 Thursday, May 21, 2009 6:13 PM
Chapter 9
Controlling Other Components
Combination Devices
If you are programming the remote to control a combination device, such as a TV/VCR or a TV/
DVD, program the remote control in one mode, and then repeat the procedure in the other mode.
For example, to program the remote to control a TV/VCR using code 748, follow the instructions to
program the remote to control the TV using code 748, and then repeat the instructions for the VCR
using the same code.
Setting Up Using Device Code Tables
You can set up the remote to control other devices using the device codes listed on page 93. In the
instructions below, the column on the left contains the instructions and the column on the right
provides additional information.
1
Turn the device on.
2
Find the brand name of the device in
the tables starting on page 93.
3
Press and hold the mode button until
all the other mode buttons light up, and
then let go of the button. The mode
button flashes.
4
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier.
5
Enter one of the three-digit device
codes from the table using the number
buttons.
6
If you want to program Limited Mode,
press PAGE UP. If not, skip to step 7.
50
Instructions Additional Information
Use the device's front panel buttons or its
remote control.
If the brand isn't listed, see Setting Up Using
Device Codes Scan on page 51.
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
This step is for programming which kind of
device that should be programmed in AUX
mode. If you're not programming in AUX mode,
skip to step 5.
The three-digit device code should be for the
brand name of your device that you found in
step 2.
See Limited Mode for more information.