Dish Network Satellite Receiver User Manual page 15

Chapter 2 381.fm Page 8 Thursday, May 21, 2009 5:52 PM
Chapter 2
Remote Control
R C
EMOTE ONTROL
The remote control gives you easy access to all the features of your satellite receiver. You can
program the remote to control the satellite receiver and up to three other devices (see page 49).
These devices can be a TV, a VCR or DVD player, and a third device.
This section describes how to use the various features of the remote control delivered with your
satellite TV system.
Remote Control Batteries
The remote control comes with four AAA batteries. When you replace old batteries,
you should replace all of the batteries. Use batteries of the same kind, for example,
alkaline or carbon zinc. Don't mix batteries of different kinds. Alkaline batteries last
longer.
1
Press down on the top of the battery cover and slide the cover off.
2
Take out all of the old batteries.
3
Put four new batteries in. Make sure you match the plus ("+") ends with the plus
markings on the battery case.
4
Slide the cover back into place.
Low Battery Warning
When you see a low battery warning
message on your screen below the
Program Banner, the batteries in your
remote control are weak and need to be
replaced.
UHF Remote Antenna
Attach the UHF remote control antenna to the receiver's
back panel REMOTE ANTENNA input so you can use
your UHF Pro remote control. Be sure to set the
antenna straight up so you can use the remote control
from as far away as possible. Don't let the antenna
touch anything.
8