Dish Network Satellite Receiver User Manual page 59

Chapter 9 381.fm Page 52 Thursday, May 21, 2009 6:13 PM
Chapter 9
Controlling Other Components
3
For AUX mode only. Press 0 for a
second TV, or 1 for a second VCR,
or 2 for a tuner, or amplifier. Then press
the STAR (*) button.
4
If you want to program Limited Mode,
press PAGE UP. If not, skip to step 7.
5
Press POWER.
6
Press the UP or DOWN ARROW
repeatedly until the device turns off.
7
Press POUND (#).
8
Turn the device back on and try some
other buttons to make sure they work.
9
If necessary, repeat this procedure until
you've tried all the codes.
52
Instructions Additional Information
This step is for programming which kind of
device that should be programmed in AUX
mode. If you're not programming in AUX mode,
skip to step 4.
See Limited Mode for more information.
This puts your remote in the scan mode.
As you press the UP or DOWN ARROW, the
remote tries each code in the memory to see if
it can turn off your device. When the device
turns off, you have found a code that might
work.
Note: The mode button for the device will flash
rapidly eight times when you've scanned all the
codes for that device.
The mode button flashes three times if you
have entered the code correctly. This stores the
code you found.
Press POWER to turn the device back on. Try
some other buttons to make sure they work.
Sometimes POWER works when other buttons
don't.
You may need to repeat the scan to find the
best code for your device.