Balancing The Head - Vinten Vision 250 Service Manual

Contents

Balancing the head

12 Balancing the Vision 250 head achieves two objectives. Firstly, when a head is correctly balanced the
operator will need a minimum amount of even effort to move the head. Secondly, once balanced, the head
and its payload can be set to any tilt position and the head will maintain this position with "hands off".
13 The graph (Fig 2.2) illustrates the relationship between load and centre-of-gravity (C of G) height and
may be used to ascertain the suitability of the head for any given combination of camera, lens and
accessories. The shaded area of the graph corresponds to those loads/C of G heights that can be balanced
over the full tilt range. The areas to the right indicate the progressively reducing tilt range over which the head
can balance higher loads.
14 Prior to balancing the head ensure that the pan bars and any ancillary equipment have been fitted in
order to prevent upsetting the balance once it has been achieved.
in. mm
8
200
190
180
7
170
160
6
150
140
130
5
120
110
4
100
90
80
3
70
60
2 50
2 4
5 10
6 8 10 12 14 16
15 20 25 30 35
Fig 2.2 Balance Graph
± 90°
18 20 22 24 26 28
40 45 50 55 60
PAYLOAD
First Previous Next
Page Page Page
± 68°
30 32 34 36 38 40
65 70 75 80 85
Previous
View
42 kg
lb
90
16