Assembly; Electrical Installation; Mechanism Housing - Vinten Vision 250 Service Manual

Contents

Assembly

NOTE: All screws are secured with Loctite 222E unless otherwise stated.

Electrical installation

16 Install the electrical installation as follows
16.1 If removed, install the PCB as follows:
16.1.1 Remove all traces of old adhesive from the mechanism housing (2)
16.1.2 Apply a thin bead of Loctite 5083 around the digital display window on the PCB and
position PCB in mechanism housing. Apply further beads of Loctite 5083 along the top and
bottom edges of the PCB
16.1.3 Referring to
PCB switch in push-button and temporarily secure outrigger to mechanism housing with screws
(16) and (17).
16.1.4 Referring to
(6), ensuring PCB is correctly seated.
16.1.5 Cure Loctite using UV light source in accordance with manufacturers instructions.
16.1.6 Remove the outrigger and the pan brake cover/PCB support from mechanism housing.
16.1.7 Secure potentiometer to mechanism housing (2) with two screws (7).
16.2 If removed, install the LED lenses (4) in the outrigger (2) and the mechanism housing (3), using
Loctite 409.
16.3 If removed, install the tilt drag LED and wiring (14) in the mechanism housing (3).
16.4 If removed, install the pan drag LED and wiring (4) in the outrigger (2). Adhere wiring in groove in
outrigger with Loctite 406.
16.5 If removed, install wiring (13) in battery housing (10) and position battery housing in outrigger (1).
Secure battery housing with Silcoset 153. Adhere wiring to outrigger with Loctite 406.

Mechanism housing

17 If removed, install the following components in the mechanism housing:
17.1 Referring to
so that it protrudes by 6 mm.
17.2 Referring to
to dry, then trim pads flush with casting.
17.3 Secure bearing (22) in mechanism housing (21) using Loctite 641.
17.4 Install dowel pin (6) in mechanism housing (21).
(Fig
Fig 6.2, install push-button (15) and 'O' ring (13) in outrigger (14). Position
Fig 6.7, install pan brake cover/PCB support (5) and secure with six screws
Fig 6.5, install pin (28) in mechanism housing (26) using Loctite 641. Drive in the pin
Fig 6.2, install rubber pads (10) in mechanism housing (21) using Loctite 415. Allow
First
Page
6.7):
Previous Next Previous
Page Page View
33