Removing The Hard Disk Drive Fan Assembly - IBM Models 5 Service Manual

Removing and replacing FRUs

Removing the hard disk drive fan assembly

To remove and replace the HDD fan assembly, follow these steps:
1. Switch OFF the power to the IBM AnyPlace Kiosk. Unplug the power cord
2. Remove the rear cover as described in "Removing the rear cover" on page 39.
3. Remove the hard disk drive ("Removing the hard disk drive assembly" on
4. Detach the HDD fan connector from the system board and remove the tape
Figure 23. Removing the HDD fan assembly
5. Loosen the two fan bracket screws a few turns ( B in Figure 23) and pull the
To replace the fan, reverse these steps.
42
IBM AnyPlace Kiosk 4838
from the external power source.
page 41) to access and remove the tape securing the connector wires.
securing the fan cable.
connector wires from beneath the system board.
B