Mounting Instructions; Tabletop Mount - IBM Models 5 Service Manual

Figure 13. Installing additional memory
2.
3. Refer to the existing memory card position for reference ( M in Figure 13).
4. Secure the memory card into the slot by rotating the memory down into
5. Install the side access door and fasten the captured screw.

Mounting instructions

You can choose between a tabletop, wall mount, or a third party mount.

Tabletop mount

This section describes how to install the AnyPlace Kiosk on a tabletop mount.
M
Loosen the captured screw holding the side access door (refer to Figure 8 on
page 16).
Insert the memory card into the memory connector.
position. The memory connector latches make a click sound, indicating that the
memory card is retained. The memory should appear aligned relative to the
connector (not angled, crooked or misaligned).
Note: Do not over tighten the screw
Installing the IBM AnyPlace Kiosk
Chapter 2. Installing the IBM AnyPlace Kiosk
21