Removing The Hard Disk Drive Assembly - IBM Models 5 Service Manual

Removing the hard disk drive assembly

Attention: Establish personal grounding before touching this unit. See
"Electrostatic discharge" on page 94.
Follow these steps to remove the hard disk drive assembly:
1. Switch off the power to the IBM AnyPlace Kiosk. Unplug the power cord from
2. Remove the hard drive door by loosening the captured screw (see Figure 12 on
Figure 22. Removing the hard drive
3. Remove the hard disk drive assembly by pressing the drive bracket ( D in
4. To replace, locate the right and left side rails with the correct side of the rails
5. Insert the hard disk drive assembly until it is latched into place.
6. Replace the hard drive door and tighten the captured screw.
the external power source.
page 20).
Figure 22) downward on the latch in the area marked in blue while pulling the
bracket outward.
Note: The HDD assembly might include a circuitry card.
upward.
Note: Do not overtighten the screw.
Removing and replacing FRUs
Chapter 4. Removing and replacing FRUs
D
41