Removing The Processor - IBM Models 5 Service Manual

Removing and replacing FRUs
5. Replace the rear cover.

Removing the processor

Note: Locate the processor after you remove the CPU fan sink assembly.
To remove the processor, follow these steps:
1. Switch OFF the power to the IBM AnyPlace Kiosk. Unplug the power cord
2. Follow the instructions described in "Removing the CPU fan sink assembly" on
Figure 25. Removing the processor
3. Using a small flat-blade screwdriver, turn the screw ( H in Figure 25) that holds
4. Lift out the processor, carefully keeping your fingers on each side of the
5. To replace, reverse this procedure.
44
IBM AnyPlace Kiosk 4838
from the external power source.
page 43.
the processor 180° (one-half turn) to release it.
Note: The lock and unlock symbols on either side of the screw assist you with
the direction of the turn.
module.
H