Replacing A Hard Disk Drive - IBM SurePOS 700 Series Hardware Service Manual

Replacing a hard disk drive

To remove a hard disk drive (HDD):
1. Follow the steps in "Opening the drive bay door" on page 37 to open the drive
2. Squeeze the two blue drive rail lock tabs ( A in Figure 25) inward and pull to
Figure 25. Removing a hard disk drive
To replace the hard disk drive, reverse the previous steps.
Note: Be sure to press the new drive on its rails into the back of the DASD cage,
38
SurePOS 700-723/743/783/784 Hardware Service Guide
bay door.
remove the hard disk drive on its rails.
to ensure a solid connection. The drive rail lock tabs will snap into place
when the drive is fully inserted.
A