Setting Functions Using The Wired Remote Controller - Mitsubishi Heavy Industries FDTC40ZHXV Technical Manual

(8) Setting functions using the wired remote controller

(a) The initial function setting for typical using is performed automatically for a remote control unit and an
indoor unit by the outdoor unit connected, when remote controller and inside unit are connected.
As long as they are used in a typical manner, there wiil be no need to change the initial settings.
If you would like to change the initial setting marked "
The procedure of functional setting is shown as the following diagram.
As for detail of setting, refer to the installation manual of remote controller.
(b) Flow of function setting
Start : While indoor unit do not operate, press "
Finalizea : Press "
Reset : Press "
Select : Press
End : Press
It is possible to finish above setting on the way, and unfinished change of setting is unavailable.
" " : Initial settings
" " : Automatic criterion
Clearing the function setting
(c)
Pressing (CHECK) +
the data which are set at the shipping from factory.
Remote controller unit functions ( FUNCTION
" (SET) button.
" (RESET) button.
button.
button.
(TIMER) +
(Remote controller function)
F F unction
setting
01
When you use at 50Hz area
When you use at 60Hz area
02
Automatic operation is impossible
03
Temperature setting button is not working
04
Mode button is not working
05
On/Off button is not working
06
Fan speed button is not working
07
Louver button is not working
08
Timer button is not working
09
10
11
12
13
14
15
16
17
18
Heating preparation indication should not be indicated.
19
", set your desired setting as for the selected item.
" (SET) and " " (MODE) button for 3 seconds at the same time.
(MODE) buttons simultaneously reverts the function setting data to
)
Remote thermistor is not working.
Remote thermistor is working.
Remote thermistor is working, and to be set for producing +3.0°C increase in temperature.
Remote thermistor is working, and to be set for producing +2.0°C increase in temperature.
Remote thermistor is working, and to be set for producing +1.0°C increase in temperature.
Remote thermistor is working, and to be set for producing -1.0°C increase in temperature.
Remote thermistor is working, and to be set for producing -2.0°C increase in temperature.
Remote thermistor is working, and to be set for producing -3.0°C increase in temperature.
In case of Single split series, by connecting ventilation device to CNT of the indoor printed circuit board, the operation of
ventilation device is linked with the operation of indoor unit.
In case of Single split series, by connecting ventilation device to CNT of the indoor printed circuit board, you can operate/
stop the ventilation device independently by (VENT) button.
If you change the range of set temperature, the indication of set temperature will vary following the control.
If you change the range of set temperature, the indication of set temperature will not vary following the control, and
keep the set temperature.
Airflow of fan becomes the three speed of - -
Airflow of fan becomes the two speed of - .
Airflow of fan becomes the two speed of - .
Airflow of fan is fixed at one speed.
If you change the remote controller function "14
you must change the indoor function "04 " accordingly.
You can select the louver stop position in the four.
The louver can stop at any position.
If you input signal into CNT of the indoor printed circuit board from external, the indoor unit will be operated
independently according to the input from external.
If you input into CNT of the indoor printed circuit board from external, all units which connect to the same remote
controller are operated according to the input from external.
In normal working indication, indoor unit temperature is indicated instead of airflow.
(Only the master remote control can be indicated. )
Temperature indication is by degree C
Temperature indication is by degree F
233
- -
.
",