Mitsubishi Heavy Industries FDTC40ZHXV Technical Manual page 191

Setup from a remote controller side.
Drain pump operation from remote control unit is possible. Operate a remote control unit by following the steps described
below.
Press the button for three seconds or longer.
The display will change "
Press the button once and cause "
When the (SET) button is pressed, a drain pump operation will start.
Display: "
If either (SET) or
system will become OFF.
If two (2) remote controllers are connected to one (1) inside unit, only the master controller is available for trial
operation and confirmation of operation data. (The slave remote controller is not available.)
Hook
1
Chain
2
Screw
3
Screw
4
Screw
5
2) Make sure that the unit main body is positioned at the correct height and the opening on the ceiling is made to the correct
dimensions with the level gauge supplied with the main body.
Remove the level gauge before you attach the panel.
3) Screw in two bolts out of the four supplied with the panel by about slightly less than 5mm. ( mark
Piping side
A
4) Attach the hook supplied with the panel to the main body with the hook fixing screw (1 screw). [Figure 2]
5) Open the air inlet grille.
6) Please remove the screw of a corner panel and remove a corner panel. (four places) [Figure 3]
"
"
button is pressed, a forced drain pump operation will stop. The air conditioning
1 piece For fixing temporarily
2 piece
4 piece For hoisting the panel
1 piece For attaching a hook
2 piece For attaching a chain
Control box
Drain hose side
B
Corner panel
184
-
" to be displayed.
Screw
-
) [Figure 1]