Mitsubishi Heavy Industries FDTC40ZHXV Technical Manual page 26

Item
Cooling power consumption
Running current (Cooling)
Power factor (Cooling)
Heating power consumption
Running current (Heating)
Power factor (Heating)
Inrush current (L.R.A) <Max. running current>
Noise level
× ×
Starting method
Refrigerant control
Defrost control
Fan type & Q'ty
Motor
Starting method
Air filter, Q'ty
Shock & vibration absorber
Electric heater
Operation switch
Room temperature control
Insulation for piping
Accessories
Optional parts
Notes (1) The data are measured at the following conditions.
Operation
Cooling
Heating
(2) This packaged air-conditioner is manufactured and tested in conformity with the following standard. ISO-T1 "UNITARY AIR-CONDITIONERS"
(3) The operation data indicate when the air-conditioner is operated at 230V 50Hz or 220V 60Hz.
(4) Values in [ ~ ] show the minimum to maximum range.
(5) Indoor unit specifications show the specifications for one unit. Capacity and running characteristics values are shown for the case where two indoor
units are combined and run together.
Model
kW
kW
kW
A
%
kW
A
%
A
dB(A)
Louver fin & inner grooved tubing
W
Pocket plastic net × 1 (washable)
W
Wired remote control switch (Optional : RC-E3)
Wireless kit (Optional : RCN-T-36W-E)
Overload protection for fan motor.
Connectable with VP20 (I.D. 20mm, O.D. 26mm)
Indoor air temperature
Item
DB
27˚C
20˚C
Hi:33 Me:31 Lo:30
–
–
–
–
Microcomputer controlled de-icer
Turbo fan × 1
×
Direct line start
Possible
Rubber sleeve (for fan motor)
–
Thermostat by electronics
Frost protection thermostat.
Necessary (both Liquid & Gas lines)
Mounting kit. Drain hose
Decorative Panel (T-PSA-36W-E)
Outdoor air temperature
WB DB
19˚C 35˚C
7˚C
25
- -
Cooling: 50, Heating: 51
81
Direct line start
Straight fin & inner grooved tubing
Electronic expansion valve
Propeller fan × 1
×
Direct line start
–
–
Rubber sleeve (for compressor)
20 (Crank case heater)
– (Indoor unit side)
–
Internal thermostat for fan motor.
Anomalous discharge temperature protection.
φ ʺ
φ ʺ
Holes size φ20 × 3 pcs
Standards
WB
24˚C
ISO-T1
6˚C
*