Installation Procedure; Installation Diagram Of Indoor And Outdoor Units; Before Installing The Wireless Remote Controller - Toshiba RAS-B10N3KV2-E Service Manual

10-1. Installation Diagram of Indoor and Outdoor Units

8
6
Flat head
Battery cover
wood screw
9
Flat head
wood screw
3
Batteries
The provided Remote Controller is a wireless type,
which also can be used as a wire.
Please see "How to Connect The Remote Controller
for Wired Operation", in case of wired control is
required.
Remark :
• Detail of accessory and installation parts can see in the accessory
sheet.
• Some pictures might be different from the actual parts.
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (− ) positions.

10. INSTALLATION PROCEDURE

5
Filter
8
Flat head
4
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
2
Wireless remote control

Before installing the wireless remote controller

2 Wireless remote controller
Hook
Installation
1
plate
Shield pipe
Remote control holder
Saddle
Extension
drain hose
(Not available,
provided by installer)
– –
48
FILE NO. SVM-12050
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Left
Bottom Rear
left
right
Bottom left
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries