How To Cancel The Auto Restart Function; Power Failure During Timer Operation - Toshiba RAS-B10N3KV2-E Service Manual

9-3-2. How to Cancel the Auto Restart Function

To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps three times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the system is on stand-by (not operating)
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
RESET button
• When the system is operating
Operation
Press [RESET] button for more than
three seconds. (Less than 10 seconds)
RESET button

9-3-3. Power Failure During Timer Operation

When the unit is turned off because of power failure
during timer operation, the timer operation is can-
celled. In that case, set the timer operation again.
NOTE :
The daily timer is reset while a command signal
can be received from the remote controller even if it
stopped due to a power failure.
The unit is on standby.
↓
The unit starts to operate.
↓
After approx. three seconds,
The unit beeps three times and continues to operate.
If the unit is not required to operate at this time, press [RESET]
button once more or use the remote controller to turn it off.
The unit is in operation.
↓
The unit stops operating.
↓
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, press [RESET] button
once more or use the remote controller to turn it on.
– –
43
FILE NO. SVM-12050
Motions
The green indicator is on.
Motions
The green indicator is on.
The green indicator is turned off.