Program Station Names - Samsung OfficeServ 7200 Technical Manual

2. Dial the station number OR use the
UP and DOWN keys to scroll through
the keyset numbers and press the
right soft key to move the cursor right
3. Press HOLD to reset the passcode
4. Press the right soft key to return to
step 2 OR press TRSF to store and exit
programming OR press SPK to
store and advance to the next program
DEFAULT DATA: ALL STATION PASSCODES = 1234

PROGRAM STATION NAMES

This program is used to assign a character name or identification for each exten-
sion. You may assign a name of 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION
1. Press TRSF and then dial 104
Display shows
2. Dial station number (e.g., 205)
OR press UP or DOWN to select the
station and press the right soft key to
move the cursor
3. Enter the station name using the
procedure described on the next page
and press the right soft key to return to
step 2
13
[205] PASSCODE
PASSCODE:
[205] PASSCODE
PASSCODE : 1234
DISPLAY
[201] STN NAME
[205] STN NAME
[205] STN NAME
SAM SMITH
Home Page
4. Press TRSF to store and exit
programming OR press SPK to store
and advance to the next program
NOTE: Directory information is always 11 characters.
DEFAULT DATA: NONE
Names are written using the keypad. Each press of a key will select a character.
Pressing the dial pad key moves the cursor to the next position. For example, if the
directory name is "SAM SMITH," press the number "7" three times to get the letter
"S." Press the number "2" once to get the letter "A." Continue selecting characters
from the table below to complete your message. Press the "A" key to change the
letter from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as does the
previous character, press the UP key to move the cursor to the right.
DCS KEYSETS
COUNT 1 2
DIAL 0 Q Z
DIAL 1 space ?
DIAL 2 A B
DIAL 3 D E
DIAL 4 G H
DIAL 5 J K
DIAL 6 M N
DIAL 7 P R
DIAL 8 T U
DIAL 9 W X
DIAL : =
The # key can be used for the following special characters: #, space, &, !, :, ?, ., %, $, -
, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \," and ~.
System Admin
Table of Contents
3 4 5
. ) 0
, ! 1
C @ 2
F # 3
I $ 4
L % 5
O ^ 6
S & 7
V Q 8
Y ( 9
[ ]
14