Program Station Names - Samsung iDCS 500 User Instruction

PROGRAM STATION NAMES

This program is used to assign a character name or identification for each
extension. You may assign a name of 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION
1. Press TRSF and then dial 104
Display shows
2. Dial station number (e.g., 205)
OR press UP or DOWN to select the
station and press the right soft key to
move the cursor
3. Enter the station name using the
procedure described on the next page
and press the right soft key to return to
step 2
4. Press TRSF to store and exit
programming OR press SPK to store
and advance to the next program
NOTE: Directory information is always 11 characters.
DEFAULT DATA: NONE
13
DISPLAY
[201] STN NAME
[205] STN NAME
[205] STN NAME
SAM SMITH
Names are written using the keypad. Each press of a key will select a char-
acter. Pressing the dial pad key moves the cursor to the next position. For
example, if the directory name is "SAM SMITH," press the number "7" three
times to get the letter "S." Press the number "2" once to get the letter "A."
Continue selecting characters from the table below to complete your mes-
sage. Press the "A" key to change the letter from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as
does the previous character, press the UP key to move the cursor to the
right.
DCS KEYSETS
COUNT 1 2
DIAL 0 Q Z
DIAL 1 space ?
DIAL 2 A B
DIAL 3 D E
DIAL 4 G H
DIAL 5 J K
DIAL 6 M N
DIAL 7 P R
DIAL 8 T U
DIAL 9 W X
DIAL ✱
: =
The # key can be used for the following special characters: #, space, &, !,
:, ?, ., %, $, -, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
3 4 5
. ) 0
, ! 1
C @ 2
F # 3
I $ 4
L % 5
O ^ 6
S & 7
✱
V 8
Y ( 9
✱
[ ]
14