Ethernet.connection; Default.address - Extron electronics CrossPoint 450 Plus Series User Manual

Ethernet Connection
Ethernet Link
The rear panel Ethernet connector on the
CrossPoint or MAV switcher can be connected to an
Ethernet LAN or WAN. This connection makes SIS control
of the switcher possible using a computer connected to the
same LAN.
Ethernet connection
The Ethernet cable can be terminated as a straight-through cable or a crossover
cable and must be properly terminated for your application (figure A-1).
•
•
Figure A-1 — RJ-45 connector pinout tables
Default address
To access the CrossPoint or MAV switcher via the LAN port, you need the
switcher's IP address. If the address has been changed to an address comprised of
words and characters, you can determine the actual numeric IP address using the
Ping utility. If the address has not been changed, the factory-specified default is
192.168.254.254.
Ping can also be used to test the Ethernet link to the CrossPoint or MAV switcher.
A-2 CrossPoint / MAV Matrix Switchers • Ethernet Connection
Crossover cable — Direct connection between the computer and the
CrossPoint or MAV switcher.
Patch (straight-through) cable — Connection of the CrossPoint or MAV
switcher to an Ethernet LAN.
Crossover Cable
Pins:
12345678
End 1
Pin Wire color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
8 Brown
Insert Twisted
Pair Wires
T568A
RJ-45
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
Connector
reversed) is a "crossover" cable.
Straight-through Cable
End 2 End 1
Wire color Pin Wire color
White-orange 1 White-orange
Orange 2 Orange
White-green 3 White-green
Blue 4 Blue
White-blue 5 White-blue
Green 6 Green
White-brown 7 White-brown
Brown 8 Brown
T568B T568B
A cable wired the same at both ends is
called a "straight-through" cable, because
no pin/pair assignments are swapped.
End 2
Wire color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
T568B