Definitions; Features - Extron electronics CrossPoint 450 Plus Series User Manual

Introduction, cont'd

Definitions

The following terms, which apply to Extron matrix switchers, are used throughout
this manual:
Tie — An input-to-output connection.
Set of ties — An input tied to two or more outputs. (An output can never be tied
Configuration — One or more ties or one or more sets of ties.
Current configuration — The configuration that is currently active in the
Global memory preset — A configuration that has been stored. Up to 32 global
Room — A subset of outputs that are logically related to each other, as
Room memory preset — A configuration consisting of outputs in a single room

Features

Video — All switchers input and output video on BNC connectors.
CrossPoint — Both switcher models input and output ultra-wideband RGBHV
MAV Plus — These switchers input and output NTSC 3.58, NTSC 4.43, PAL, or
Bandwidth —
CrossPoint — Both CrossPoint switcher models provide a minimum of
MAV Plus — The MAV Plus switchers provide a minimum of 150 MHz (-3 dB)
Audio inputs (audio models) —
All audio models, with the exception of the MAV Plus 128 AV RCA — Input
MAV Plus 128 AV RCA — Input and output unbalanced stereo audio on left and
1-8 CrossPoint / MAV Matrix Switchers • Introduction
to more than one input.)
switcher (also called configuration 0)
memory presets can be stored in memory. Preset locations are assigned
to the input buttons and (where necessary) output buttons. Up to 20 or
32 (depending on the number of input and output buttons) presets can be
selected from the front panel for either saving or retrieving. When a preset
is retrieved from memory, it becomes the current configuration. All models
have 32 presets; on models with fewer than 32 input and output buttons,
preset numbers that are too high to be available from the front panel are still
accessible under serial port or Ethernet control.
determined by the operator. The switchers support up to 10 rooms, each of
which can consist of anywhere from 1 to 16 outputs.
that has been stored. When a room preset is retrieved from memory, it
becomes the current configuration. The switchers support up to 10 presets
per room.
or RGBS video. They can also switch RGsB, RsGsBs, component/HDTV,
S-video, or composite video.
SECAM video or HDTV video inputs. Depending on the video format of
the switcher, these switchers can distribute low resolution RGsB, RsGsGs,
component/HDTV, S-video, or composite video.
425 MHz (-3 dB) video bandwidth, fully loaded.
video bandwidth, fully loaded.
and output stereo audio, balanced or unbalanced, on 3.5 mm, 5-pole captive
screw terminals.
right RCA connectors.