Example.6:.Setting.the.rgb.delay.for.an.output - Extron electronics CrossPoint 450 Plus Series User Manual

Example 6: Setting the RGB delay for an output
In the following example, the RGB delay is increased for output 17. The steps show
the front panel indications that result from your action.
1. Press and release the Esc button (figure 3-37).
Press the Esc button to clear all selections.
ENTER
Figure 3-37 — Clear all selections
2. Press and hold the RGBHV button for approximately 2 seconds (figure 3-38).
Press and hold the RGBHV
button until it blinks.
Figure 3-38 — Select RGB Delay mode
3. Press and release the Output 17 button (figure 3-39).
1
Press and release the
17 18 11 32
Output 17 button.
The button lights green.
Figure 3-39 — Select an output
N The RGB delay is protected when front panel lock mode 2 is selected. You
can view the delay in lock mode 2, but not change it from the front panel. See
"Setting the front panel Locks (Executive modes)" on page 3-52.
If front panel lock mode 2 is selected and you try to perform steps 4, the actions
are ignored and the Enter, RGBHV, and Audio buttons flash.
C O N T R O L
VIEW ESC
PRESET
The button flashes once.
RGBHV RGBHV
2 seconds
The input buttons 1 through 10 display the selected
output's RGB delay.
Each lit input button indicates half a second of delay.
In this example, the lit input buttons display 3.5
seconds of RGB delay.
0.5
O
2 5 16 1
U
T
P
U
17 18 19 20 21 22 23 24 31 32
T
S
CrossPoint / MAV Matrix Switchers • Operation
1.0 1.5 2.0 2.5 3.0 3.5
2 3 4 5 6 7
I
8 15 16
N
P
U
T
S
3-29