Danfoss DLX 2.0 Installation Manual page 29

4. Time
NOTICE
The time setting must match the time on the actual installation site, otherwise
data may be overwritten!
5. Set Bus ID
If RS485 communication is used, set a unique bus ID for the inverter. For any follower
inverters, this will be required to be set manually under Setup > Network Setup > Bus ID
(RS485). If RS485 communication is not used, this step can be missed.
6. Set as Master Unit
Installation Guide DLX seriesL00410622-01
HH.MM (24 H)
Enter – Call up the time
Up – Increase present digit
Down – Decrease present digit
Right – Select next digit
Left – Select previous digit
Enter – Confirm
Left – Back
Right – Next
Enter – Confirm
Enter – Call up the digits
Up – Increase present digit
Down – Decrease present digit
Enter – Confirm
Left – Back
Right – Next
Enter – Confirm
Default – No
Enter – Call up the options: Yes or No
Up – Yes
Down – No
Enter – Confirm
Left – Back
Right – Next
Enter – Confirm
29