Unpacking And Inspection - Danfoss DLX 2.0 Installation Manual

Table 1.2: Symbols appearing on the product label
Symbol Description
Discharge time: High voltages may be present inside the inverter for 1 hour after
switch OFF
Refer to User Guide: Look for further details in the User Guide, which is available
on the Danfoss website
Hot Surface: The heat sink on the back of the inverter can reach temperatures up
to 90 °C
Danger: High voltages are present
Disposal: Do not dispose in general waste! Collect the various parts separately
and recycle them according to local regulations
CE Marking: The product meets the EU safety, health and environmental
protection requirements
S – NO: Serial Number for inverter identification

1.3. Unpacking and Inspection

After unpacking the inverter safely, check that all components are present and in an
undamaged condition. If damaged, contact your supplier immediately!
1.3.1. Lifting and Carrying the Inverter
Considering the inverter's weight of 20-22 kg, (depending upon model), lifting and
carrying the inverter must be correctly performed to prevent back injuries.
Figure 1.3.1: Correct lifting of the inverter
Installation Guide DLX seriesL00410622-01
• When lifting, bend the knees, and keep
the back straight.
• Lift carefully; hold the inverter close to the
body and let the leg muscles do the work.
• Turn the whole body as one unit to avoid
twisting the lower back.
• Carry the inverter close to the body.
5