Checks Prior To Installation - Danfoss DLX 2.0 Installation Manual

Table of Contents

Advertisement

Figure 2.2.5: Mounting Inverter onto bracket

2.3. Checks Prior to Installation

Make sure that the AC circuit breaker(s) and the DC switch(es) are OFF and that the
terminals are in a discharged state to prevent shock hazards.
DANGER
Contact with energized ports may cause lethal injuries! All installation of the
inverter must be performed with circuits de-energized!
All electrical installations shall comply with the local and national electrical regulations
in force at the installation site.
Check that the PV and the grid characteristics are compatible with the inverter
characteristics. Refer to 9. Technical Data
Check that the inverter is properly fastened and secured to the bracket.
Ensure that the conductors and circuit breakers/fuses are properly sized to comply with
the national electrical regulations.
12
• Lift the inverter up and guide the
upper hooks into the slots on the
bracket.
• Control the lower hooks into the
slots and slide the inverter onto
the bracket.
• Ensure that the inverter is
correctly mounted, and tighten
the lock clip with one screw into
the inverter and one into the
Stringbox.
• Apply a torque of 1.0 Nm
Installation Guide DLX series L00410622-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dlx 2.9Dlx 3.8

Table of Contents