Runco Video Xtreme VX-40d Owner's Operating Manual page 79

Handle lamp with care. Lamp may explode if dropped.
Wear protective clothing and safety goggles when
Use only Runco approved lamps provided for your projector.
1. Press to power down the projector. Wait at least 5 minutes to allow the internal cooling
fans to stop before unplugging the projector. This wait period is also required to allow the
lamp to sufficiently cool before handling.
Always power down and unplug the projector prior to servicing.
Allow the lamp to cool before handling.
2. Using a screwdriver, loosen the 4 screws from the lamp door located at the back of
the projector, below the input panel. (Figure 4.2.)
3. Pull (out) and turn the lamp lock lever, which is located to the left of the lamp module,
a quarter turn counter clockwise to the "unlock" position. (Figure 4.3.)
4. Grasp the lamp by its housing only and pull it straight out (lamp slides along guides)
until it's free. (Figure 4.4.) Discard the lamp using safe disposal/recycling practices or
contact your Runco dealer for a possible re-lamping program.
WARNING
handling lamps.
WARNING
Lamp door - 4 screws
Figure 4.2
Figure 4.3
79
Section 4: Maintenance