Runco Video Xtreme VX-40d Owner's Operating Manual page 31

OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
NOTE: You must have an unlocked channel present to use Auto Setup.
Channel
Press Channel to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a 2-digit channel number (or, if there is a list displayed, highlight it
and press ), the display will automatically change and update according to the numerous
setup parameters defined for that channel. Note that a new channel is automatically
created if you adjust an image from a new source.
NOTE: Channel ( Channel ) key behavior during a presentation depends on whether or
not the Display Channel List option is enabled in the Menu Preferences menu. You
can choose to use a scrollable list of channels when you press Channel, or you may
prefer to enter the desired channel number "blind", i.e., without on-screen feedback. See
Menu Preferences later in this section.
Input 1
Press Input 1 to display from the data or video input source connected to BNCs labeled
INPUT 1.
Input 2
Press Input 2 to display from the DVI source connected to INPUT 2.
Input 3
Press Input 3 to display from the composite video source connected to INPUT 3.
Input 4
Press Input 4 to display from the S-video source connected to INPUT 4.
Input 5
Press Input 5 to display from the INPUT 5 interface module installed in the Option 1
slot.
NOTE: If you have the optional Dual SD/HD-SDI Module installed and there are two
inputs connected here, the second input (B) is considered INPUT 7. If you are using the
built-in keypad or the remote keypad, press INPUT 5 to access INPUT 7 as follows:
• While displaying from INPUT 5, press Input 5 again. This switches to INPUT 7.
• While displaying from any input other than the Dual SD/HD-SDI Module, press Input 5 .
This switches to either INPUT 5 or INPUT 7, depending on which of the Dual SD/HD-
SDI Module inputs (A or B) was last used. Press Input 5 again to display from the other
Dual SD/HD-SDI Module input.
What an "Auto Setup" Does
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail (if video source)
Filter
Luma Delay
Table 3.1 Auto Setup
31
Section 3: Operation