Ethernet Communications; 2.5 Power Connection - Runco Video Xtreme VX-40d Owner's Operating Manual

Section 2: Installation and Setup
Ethernet Port

2.5 Power Connection

Connecting RS-422
If you wish to control the projector with an automation system with RS-422 capability
and a DHD Controller is not used (not recommended), connect a RS-422 serial
communication cable between the automation system and the RS-422 port on the
projector. RS-422 is better suited for serial communication over long distances than is
RS-232 communication.
Use the RS-422 port only if your device had RS-422 capability — always consult the
literature provided with your equipment before connecting. Connecting to the RS-422
port with incompatible equipment could damage your projector.
Reserved for future use.
➤
Plug the power cord to the AC receptacle located at the back of the projector, below
the input panel, and the 3-pronged end into a grounded AC outlet. The input voltage to
the projector must be capable of 100 – 240 VAC for the VX-40d and VX-60d and 200-
240VAC for the VX-50d and VX-80d. (See also Section 6 – Specifications for complete
details on all power requirements.)
Use the approved North American-rated power cord supplied with the projector. If you are
connecting to an area outside of North America make sure you are using an appropriately
rated power cord.
Always power down the projector before unplugging the AC power cord. Wait 5-
10 minutes for the main exhaust fan to turn off and for the lamp to cool sufficiently before
unplugging the projector.
Do not attempt operation if the AC supply and cord are
Wait for the cooling fans to turn off before unplugging the projector.
Figure 2.14 Connecting RS422
WARNINGS
not within the specified voltage and power range.
24
������� � �����
������ �����