Runco Video Xtreme VX-40d Owner's Operating Manual page 75

Lamp: The projector uses a Cermax® Xenon lamp to deliver its high brightness. A lamp
should be replaced when it has reached its end of life (1000 hrs, typical) or if a noticeable
change in brightness or excessive lamp flicker occurs. Keep track of the number of hours
the lamp has been in use (Lamp Menu) and be aware of any changes to brightness.
These indicators will help you effectively maintain operation of the projector.
Wait approximately 5 minutes after powering down
the projector to allow internal cooling fans to stop and for
the lamp to cool sufficiently before removing.
The lamp is under great pressure when hot and may explode causing
physical injury and/or property damage. Allow a lamp to cool before
handling or unplugging the projector.
Use lamps of the correct wattage for your projector model
Use only lamps supplied by Runco.
Refer to 4.4 Lamp Replacement for instructions.
Use only the attachments and/or accessories recommended by Runco. Use of others
may result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied. Do not attempt operation if the
AC supply is not within the specified voltage and power range.
Refer to the Specifications in Section 6.
• Do not set or rest items on the power cord. Place the projector in an area where
the projector cord cannot be abused or damaged by persons walking on it or by
objects rolling over it.
• Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
• The projector is equipped with a three-wire plug having a third grounding pin. This
is a safety feature – if you are unable to insert the plug into an outlet contact an
electrician to have the outlet replaced. Do not defeat the safety purpose of this
grounding-type plug.
WARNING
WARNING
when replacing.
WARNING
75
Section 4: Maintenance