Important:
Please note the below scenarios for power applying because it will affect the battery life if the steps are
not correct (this is also mentioned at Physical Installation and Wiring section in this user manual):
a)
If it is powered by batteries or powered by batteries first then applied with 24Vac before Z‐Wave
inclusion, ZTS‐110 will self‐configure to FLiRS mode which will save battery life by sleeping.
b)
If it is powered by 24Vac or powered by 24Vac first then applied with batteries before Z‐Wave
inclusion, ZTS‐110 will self‐configure to Always Listening Mode which will not sleep.
c)
After inclusion process, ZTS‐110 will not detect power source and not allow changing operation
mode. You must perform exclusion process first if need to change Z‐Wave operation mode.
d)
After Z‐Wave inclusion process, if you reset ZTS‐110 to default while both 24Vac and batteries are
applied, ZTS‐110 will take 24Vac as primary power source and self‐configure to Always Listening
Mode, because reset to default process will automatically exclude ZTS‐110 from the Z‐Wave
network. You should disconnect the power source and re‐apply the power so ZTS‐110 can detect
the power source type and self‐configure to corresponding mode.
Remark:
‐ If you are using battery and somehow it is in Z‐Wave Always Listening Mode, or if you are using
battery as back up, and the AC power is down, the battery will drain very fast (battery will only
survive 3‐5 days).
‐ Regardless the FLiRS mode or Always Listening Mode, the setup and operations are same, and you
can also use local control while is it included to Z‐Wave network.
Z‐Wave Add (Include) / Delete (Exclude) into/from Z‐Wave network
Add (Include) ZTS‐110 to Gateway / Controller Z‐Wave network
Symbol
Step Procedure / Description
Gateway / Controller device should
be set to inclusion mode.
1
Press and hold "Home" key for 2
seconds to set ZTS‐110 to Add
(Include) / Delete (Exclude) Mode.
Press "Prog" key once, it will
search the network.
2
Inclusion and Exclusion Mode Key Description
Add (Include) / Delete (Exclude)
LCD indication
28