If the ZTS‐110 is added into the
network successfully, the signal of
"done" will appear.
3
Press "Home" key once to go
back to the home page.
will appear on the main
4
display.
Note:
It is recommended to perform the Delete/Exclude procedure before doing Add/Include. This is to
make sure the ZTS‐110 is not in any other Z‐Wave network which will result in failure in Inclusion
process.
If the inclusion is failed, try exclusion, and/or reset ZTS‐110 to factory default and try inclusion again.
After ZTS‐110 is included to Z‐Wave network, it will stay in Easy mode by default.
You can enable or disable Easy mode by local "Setting Mode" or Z‐Wave parameter number 8.
(please refer to parameter table at Z‐Wave Configuration Parameters).
Delete (Exclude) ZTS‐110 from Gateway / Controller Z‐Wave network
Step Procedure / Description
Gateway / Controller device should
be set to Exclusion mode.
1
Press and hold "Home" key for 2
seconds to set ZTS‐110 to Add
(Include) / Delete (Exclude) Mode.
Press "Prog" key once, it will
search the network.
2
If the ZTS‐110 is removed from the
3
network, it shows no connection.
LCD indication
29