Remotec ZTS-110 Z-Thermostat User Manual page 23

enable event during the time
setting.
If the event is disabled, "OFF" will
be displayed.
If the event is enabled, time will be
displayed and Hour will keep
flashing.
Press "Prog＂ key once to
confirm the setting and it will go to
target setting.
If the event is enabled, it will go to
target setting.
6
Target will keep flashing, press
Up/Down key to adjust Heat set
point for heating.
If the event is disabled, it will go to
next event setting.
Press "Prog＂ key once to
confirm the setting and it will go to
target setting.
7
Target will keep flashing, press
Up/Down key to adjust Cool set
point for cooling.
Press "Prog＂ key once to
confirm the setting and it will go to
next event mode.
8
Follow the program UI to complete
the whole scheduling or press
Home key once to save and exit.
23
⇓
‐