Short Cycle Start Up Protection; Energy Saving Mode; Z-Wave Setup And Operations - Remotec ZTS-110 Z-Thermostat User Manual

Short Cycle Start Up Protection
To protect the compressor / Heat pump, those outputs forced off until 3minutes count down
finished. Those outputs can be activated according to the room temperature after 3 minutes.
System
Non Heat pump system
Heat pump system
Energy Saving Mode
Step Procedure / Description
User can enable/disable energy
saving mode by using Z‐Wave
BASIC set command only. (you may
refer to the Z‐Wave primary
controller UI for it)
=> Enable energy saving mode
Basic set value = 0x00 (Off)
1
(energy saving mode will be mapped
to off mode)
=> Disable energy saving mode
Basic set value = 0xFF (Resume)
(comfort mode will mapped to
resume mode)
Z‐Wave Setup and Operations
Setting FLiRS or Always Listening mode
•
Setting to Z‐Wave FLiRS mode with batteries as power source
ZTS‐110 will self‐configure to FLiRS mode if it is powered by batteries or powered by batteries first
then applied with 24Vac before Z‐Wave inclusion. FLiRS mode is targeted for battery operated
applications and will enter sleep mode frequently in order to save battery life. ZTS‐110 can't act as
a repeater in this mode. The response to Z‐Wave command is not as quick as Always Listening
Device. Normally there is 1‐2 seconds latency on response, you should avoid sending commands to
ZTS‐110 too frequently.
•
Setting to Z‐Wave Always Listening mode with 24Vac as power source
ZTS‐110 will self‐configure to Always Listening Mode if it is powered by 24Vac or powered by 24Vac
first then applied with batteries before Z‐Wave inclusion. Always Listening mode is targeted for AC
power operated applications and it can act as a repeater which will re‐transmit the RF signal to
ensure that the signal is received by its intended destination by routing the signal around obstacle
and radio dead spots. The response to Z‐Wave command is immediate.
Output
Compressor
1st stage heat and compressor
LCD indication
27