10 - 2 DS3578 With FIPS Digital Scanner Product Reference Guide
Connecting to an IBM 468X/469X Host
This connection is made directly from the cradle to the host interface.
Host Port Connector
IBM Direct Connection
Figure 10-1
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different from those illustrated, but the steps to connect the cradle remain
the same.
NOTE Disconnect the power supply before changing host cables or the digital scanner may not recognize the
new host.
Connect the modular connector of the IBM 46XX interface cable to the cable interface port on the cradle. See
1.
Connecting the Cradle on page
Connect the other end of the IBM 46XX interface cable to the appropriate port on the host (typically Port 9).
2.
Connect an external power supply.
3.
Ensure all connections are secure.
4.
Pair the digital scanner to the cradle by scanning the bar code on the cradle.
5.
Select the port address by scanning the appropriate bar code from
6.
To modify other parameter options, scan the appropriate bar codes in this chapter.
7.
NOTE The only required configuration is the port address. Most other digital scanner parameters are typically
controlled by the IBM system.
1-6.
Interface cable
Figure 10-1
Port Address on page
are examples
10-4.