Wireless Beeper Definitions - Motorola DS6878 Reference Manual

Radio Communication Default Table (Continued)
Table 4-1
Variable Pin Code
Encryption
Secure Simple Pairing IO Capability
(SPP Server and SPP Master Host Mode Only)

Wireless Beeper Definitions

When the digital scanner scans the pairing bar code it issues various beep sequences indicating successful or
unsuccessful operations.
additional beeper definitions, see
Wireless Beeper Definitions
Table 4-2
Beeper Sequence
Four long low beeps
Five high beeps
High/low/high/low beeps
Low/high beeps
High/low beeps
Long low/long high beeps
Long low/long high/long low/
long high beeps
Parameter
Table 4-2 defines beep sequences that occur during pairing operations. (For
Beeper Definitions on page
1. A transmission error was detected in a scanned symbol. The data is
ignored. This occurs if a unit is not properly configured. Check option setting.
2. When communicating with a cradle, the cradle acknowledges receipt of
data. If the acknowledgment is not received, this transmission error beep
sequence sounds. Data may still have been received by the host. Check the
host system for receipt of transmitted data. If data was not received by the
host, re-scan the bar code.
Emitted every 5 seconds while a reconnection attempt is in progress. (See
Auto-reconnect Feature on page
Pairing bar code scanned.
Bluetooth connection established.
Bluetooth disconnection event.
Note: When connected to a remote device using SPP or HID, if a disconnect
beep sequence sounds immediately after a bar code is scanned, check the
host device for receipt of transmitted data. It is possible that an attempt was
made to transmit the last bar code scanned after the connection was lost.
Page timeout; remote device is out of range/not powered.
(See Auto-reconnect Feature on page
Connection attempt was rejected by remote device.
Note: In the case of
connected to another digital scanner in single Point-to-Point locked mode, or
the piconet may be full in Multipoint-to-Point mode. If Pair On Contacts is
enabled and the digital scanner that is inserted is already connected to the
cradle, no beeping occurs.
Radio Communications
Default
Static
Disable
No Input/No Output
2-1.).
Indication
4-15.)
4-15.)
Pairing Methods on page
Page
Number
4-28
4-29
4-30
4-22, the cradle may already be
4 - 3