Inline Fuel Filter; Engine Oil - E-TON Viper 90R Owner's Manual

Inline fuel filter

Your ATV is equipped with an inline fuel filter to
prevent dirt and debris from entering the carburetor
and engine.
Check the filter for dirt or damage before each ride
and at each refueling. Replace the filter if dirty or
damaged.
The filter should be replaced every 600 hours of
operation and at the start of each season.
To change the inline fuel filter
1
8
1. Inline fuel filter
2. The fuel cock
To replace the filter, first turn the fuel cock to the
2
8-11
"OFF" position. Then carefully compress the wire
clamp rings until the clamp is free of the fuel line.
Slide each clamp away from the filter about 3/4".
Remove the filter from the fuel line by holding the
line and pulling the filter. Install the new filter by
inserting the filter into the fuel line and returning
the clamps to the original position.
Turn the fuel cock to the "ON" position and check
for leaks. Inspect the fuel lines for cuts, abrasions
and deterioration. Replace fuel lines as needed.
DO NOT operate or start the engine if the fuel
filter or lines are leaking. Leaking fuel can cause
a fire.

Engine oil

The engine oil level should be checked before
each ride. In addition, the oil must be changed at
the intervals specified in the periodic maintenance
and lubrication chart.
To check the engine oil level
1. Place the ATV on a level surface.
2. Check the engine oil level on a cold engine.