E-TON Viper 90R Owner's Manual page 98

4. Remove the engine oil filler cap, and then
remove the engine oil drain bolt to drain the
oil from the crankcase.
1. Engine oil drain bolt
2. O-ring
3. Spring
8
4. Oil filter element
5. Check the washer for damage and replace it if
necessary.
6. Install the engine oil drain bolt, and then tighten
it to the specified torque.
Tightening torque:
Engine oil drain bolt:
8 Nm (0.8m·kgf, 5.8 ft·lbf)
7. Add the specified amount of the recommend-
ed engine oil, and then install and tighten the
engine oil filler cap.
Recommended oil:
See page 10-2.
Oil quantity:
0.75 L (0.80 US qt) (0.66 Imp.qt)
4
NOTICE
3
Do not mix any chemical additives. Do not
2
use oils with a diesel specification of "CD"
1
or oils of a higher quality than specified.
In addition, do not use oils labeled "ENERGY
CONSERVING II" or higher.
Make sure that no foreign material enters
the crankcase.
8. Start the engine,check oil lubrication by oil
check bolt, and then let it idle for several min-
utes while checking it for oil leakage. If oil is
leaking, immediately turn the engine off and
check for the cause.
9. Turn the engine off, wait at least ten minutes,
and then check the oil level and correct it if
necessary.
8-13