Sw4 Setting; Sw5 Setting; Connected Outdoor Unit Series; Draft Prevention Setting Switch (Only For Cassette Type) - Fujitsu Airstage V series Service Manual

External input select edge / pulse
This switch is used to select the format of external input command as shown in
the table below.
(
External input select
SW3-4
OFF
ON
SW4 setting (Never change at the site)
Indoor unit model code
This switch for changing the model code information of indoor unit PCB.
INDOOR UNIT MODEL CODE
7
SW 4-1 OFF
SW 4-2 OFF OFF
SW 4-3 OFF OFF
SW 4-4 OFF OFF

SW5 setting

Wireless remote controller custom code switch
Decide the custom code and restrict the type of infrared control signal, in order to prevent
mixing of multiple indoor unit signals.
Remote controller custom code switch
(
SW5-1 SW5-2
OFF OFF
ON OFF
OFF ON
ON ON

Connected outdoor unit series

Selecting outdoor unit series.
(
SW5-3 Outdoor unit series
OFF
VRF V series
ON
VRF S series
Set to ON for connecting S series outdoor unit.

Draft prevention setting switch (only for cassette type)

Set the flap angle of cassette type unit.
Draft prevention switch
(
SW5-4 flap angle
OFF Normal position
ON Draft prevention position
Factory setting)
Edge
Pulse
9 12 14 18
ON OFF ON OFF
ON ON OFF
OFF OFF ON
OFF OFF OFF
Factory setting)
Custom code
Type A
Type B
Type C
Type D
Factory setting)
Factory setting)
20 25(24) 30 36
ON OFF ON OFF
OFF ON ON OFF
ON ON ON OFF
OFF OFF OFF ON
1
3
1. Press the MASTER CONTROL button for
more than five seconds to start the code
change.
2. Press the (+) or (-) button to select the
desired code.
3. Press the MASTER CONTROL button again
to end the code change.
Normal position
Flap angle
35 - 65
An air flow direction, by moving the flap angle horizontally,
It can prevent that a cold wind directly hits.
*If air conditioning cooling operation is performed in
long time and a humid place, there is a possibility
that waterdrop may hang down from a blow-off mouth.
02-17
45 54 60
ON OFF ON
OFF ON ON
OFF OFF OFF
ON ON ON
2
Remote controller
A B C D
Draft prevention position
Flap angle
25 - 65
90
OFF
OFF
ON
ON