While Operating - Mytee Grand Prix HP-100 User Manual

HP-100/HP-60
7. Plug machine's cord into a grounded wall outlet.
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with
the use of an extension cord.
MACHINE OPERATION
1. After you have completed the
machine setup procedures, turn pump
switch on.
2. Prime the pump by pulling up on tool lever
to release air in the line. Hold lever until you
have a steady flow of water coming out of the
tool.
3. Once pump is primed and you have
pressure in the solution line, turn on
heater switch(s) and wait a few minutes
for water to heat up.
NOTE: When cleaning upholstery, always
check cleaning instructions sewn in
furniture by manufacturer.

WHILE OPERATING

1. Work away from outlet and power cord to
prevent cord damage.
2. Use a recommended foam control solution in
the recovery tank to prevent vacuum motor
damage. Periodically check for excessive foam
buildup in solution tank, and recovery tank.
3. To clean heavily soiled areas, repeat cleaning
path from different direction.
4. When ball float shuts off vacuum, it is time to
empty the dirty water from the recovery tank, and
refill solution tank.
5. After cleaning, relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning main power switch off.
www.unoclean.com
4. Turn on vacuum power
5. Begin cleaning
6