FRONT BACK 1. Waist high controls 6. Easy open lid 2. Vacuum hose connector 7. Bucket-high drain valve 3. Operating instructions on board 8. Motor base housing 4. Solution tank 9. Quality casters 5. Blower attachment ACCESSORIES FILL SOLUTION TANK 8400 - 3”...
ATTACH HOSES PUMP Firmly attach hose and quick disconnect. Make sure quick discon- After the machine has been plugged into a 20 amp grounded nects snap together firmly. Once attached to unit connect Q.D. to outlet, turn on pump. Key tool until upholstery tool releases a upholstery tool.
ENGLISH BLOWER ATTACHMENT FOR DRY VACUUMING ATTACH AUTO VAC Connect blower attachment for drying (optional). Attach our Auto Vac dry vacuum attachment (AV1) to your extrac- tor, it acts as a dry vacuum receptacle to avoid clogging extractor with dirt and debris (optional). RECOVERY TANK 45 DEGREE SPOUT DRAIN Add a defoamer in the recovery tank to reduce foam, prolonging...
If damage is evident, save the shipping carton so that it can we at Mytee Products Inc. strive to keep you on the cutting edge with superior be inspected by the carrier that delivered it. Contact the carrier immediately to file a quality and technology.
4. Filters clogged, remove filters and rinse clean with water. 8. Wait 8–10 minutes for unit to pre-heat. 5. Heater is blocked; flush out with Mytee’s system maintainer. 9. Re-key upholstery tool until hot water begins flowing. 6. If brass check valve is stuck replace valve.
EVENT SHALL MYTEE BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, PROPERTY DAMAGES, OR PERSONAL INJURIES. All limited warranties are void for, and Mytee does not warrant in any way, any prod- uct that evidences misapplication, improper installation, abuse, lack of maintenance,...