Operating The Mytee Lite; Emptying The Solution & Recovery Tanks - Mytee Lite 8070 User Manual

2.4 - Operating the Mytee Lite™

Switching On The Unit
In order to avoid vapor locking the unit, the Mytee Lite's™
components should be switched on by following the pro-
cedure below:
1. Turn pump switch on.
2. Pull the lever on the cleaning tool to release air in the
line. Hold lever until a steady flow of water comes out of
the wand.
3. Once pump is primed and there is pressure in the solu-
tion line, turn on heater switch and wait a few minutes for
water to heat up.
4. Once water is heated, turn on vacuum and begin clean-
ing.
Note: When cleaning upholstery, always check manufac-
turer's cleaning instructions.
3
Cleaning With The Mytee Lite™
For best results when extracting, do one wet pass followed
by two dry passes. This ensures you're not over-soaking
the material and also gives the heater time to catch up.
New & Reconditioned Equipment & Parts - www.southeasternequipment.net
1 2
13
2 - MACHINE OPERATION
2.5 - Emptying the Solution & Recovery Tanks
The solution tank drain is located on the front, lower left
corner of the solution tank.
The recovery tank drain is located on the back of the
machine at the bottom of the recovery tank. Attach the
included recovery tank drain hose in order to easily empty
into a bucket or other receptacle.
♦