Pre-Operation; Machine Set Up - Mytee Grand Prix HP-100 User Manual

HP-100/HP-60

PRE-OPERATION

1. Vacuum carpet and upholstery and remove
other debris.
2. Perform MACHINE SETUP procedures.
3. Inspect power cord for damage.
MACHINE SET UP PROCEDURES
1. Carefully check carton for signs of damage.
Report damage at once to freight carrier. The
machine is shipped fully assembled and is
ready for use.
2. Open lid of solution tank. Fill solution tank
with water or approved cleaning agent.
WARNING: Flammable materials can
cause an explosion or fire. Do not use flammable
solutions or materials in tank(s).
FOR SAFETY: When using machine, follow
mixing and handling instructions on chemical
containers.
ATTENTION: If using powdered cleaning
chemicals, mix prior to adding.
3. Attach male quick disconnect (qd) from
solution hose to female qd on front of extractor.
NOTE: Make sure the quick
disconnects snap together firmly. As
you do this, always inspect hoses for
cracks or fraying. Do not use if hoses
are damaged.
4. Attach other end of solution hose to
upholstery tool.
5. Attach vacuum hose to recovery tank.
6. Attach other end of vacuum hose to
upholstery tool.
www.unoclean.com
5