Installing A 3.5-Inch Hard Drive - HP ProDesk 405 G2 Microtower Maintenance And Service Manual

Installing a 3.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Slide the drive into the drive bay (1) and install the four 6-32 mounting screws (2) to secure the drive in
place.
NOTE:
Refer to
replacing a hard drive, use the four 6-32 mounting screws that were removed from the old drive to
install the new one.
4. Connect the power cable and data cable to the back of the hard drive.
5. If installing a new drive, connect the opposite end of the data cable to the appropriate system board
connector.
NOTE:
to avoid any hard drive performance problems. If you are adding a second hard drive, connect the data
cable to the light blue SATA connector labeled SATA1.
6. Replace the computer access panel.
7. Reconnect the power cord and any external devices, then turn on the computer.
8. Lock any security devices that were disengaged when the access panel was removed.
(Access panel on page
HP has supplied four extra 6-32 mounting screws on the front of the chassis behind the bezel.
Drives on page 33 for an illustration of the location of the extra mounting screws. When
You must connect the primary hard drive data cable to the dark blue connector labeled SATA0
(Preparation for disassembly on page
24).
23).
Drives 39