Preliminary Work; Heater Unit Installation Location - Webasto Mazda 3 MPS Installation Instructions Manual

Preliminary Work

WARNING!
- Open the tank cap, ventilate the tank.
- Close the tank cap again.
- Disconnect the battery.
- Let off pressure in the cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Remove the engine design cover.
- Completely remove the battery.
- Completely remove the air filter with intake hose.
- Loosen the top of the thermal insulation cover in the right of the engine compartment.
- Remove the thermal insulation cover in the middle of the engine compartment (2x plastic nuts)
- Hang the hydraulic oil container for servo steering out
- Remove lower engine cover
- Remove the panelling for the rear right axle
- Remove fuel tank according to manufacturer's instructions
- Remove tank mounting according to manufacturer's instructions.
- Remove the glove compartment on the passenger side.
- Remove the A-pillar panel in the passenger side footwell.
- Remove the left cooling water reservoir cover
Remove page 27 "Operating instructions for the end customer" and insert with vehicle operating
instructions.
1
1311472A

Heater Unit Installation Location

1 Heater unit
1
Mazda 3 MPS
Installation
location
5