Fuel Connection; Harness - Webasto Mazda 3 MPS Installation Instructions Manual

Fuel Connection

CAUTION!
Open the vehicle's tank-cap lock, ventilate the tank and then re-close the tank lock.
Catch any fuel running off with an appropriate container.
Install fuel line and metering pump cable harness so that they are protected against stone impact.
Unless specified otherwise, always fasten using cable clips.
Fit the fuel line and cable harness with edge protectors around sharp edges.
WARNING!
The fuel line and cable harness to the metering pump should be installed based on the cable harness
installation diagram.
7
1
1
1311472A
32
2
33
3
2
34
Install the fuel line 1 and the heater unit cable
harness 2 on the original vehicle fuel lines
and secure with cable ties.
1
2
Install the fuel line 1 and the heater unit cable
harness 2 on the original vehicle fuel lines
and secure with cable ties.
Run this along the right side of the vehicle,
behind the thermal insulation covers and
along the original vehicle lines.
Placement of the fuel pipe 2 is done together
with the metering pump cable harness 1 to
the vehicle underbody behind the insulation
3.
Mazda 3 MPS
Placement
of the fuel
line in the
engine
compart-
ment
Placing the
fuel pipe
Placing the
fuel pipe
18